The Idler Assembly
g285713
Figure 184
1.
Socket-head screw (2 each)
9.
Stub shaft
2.
10.
Flocked seal (2 each)
3.
Motor adapter
11.
Bearing
4.
Bushing
12.
Retaining ring
5.
Idler arm
13.
Flange nut
6.
O-ring
14.
Clevis pin
7.
Lock nut (2 each)
15.
Cotter pin
8.
Shield
16.
Collar
The groomer idler assembly is located on the opposite side of the groomer gear
box.
Removing the Idler Assembly
1.
Remove the cutting unit from the machine and place it on a level work
surface.
2. Remove the groomer reel assembly; refer to
(page 8–14)
.
3. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
4. Remove the two socket-head screws that secure the motor adapter to the
cutting unit, and remove the adapter and idler assembly. Retrieve and
discard the O-ring and lock nuts.
5. Inspect the shields, bearing, and bushing in the idler assembly. Replace any
components that are worn or damaged.
Installing the Idler Assembly
1. If the shields, bearing, or bushing was removed from the idler arm:
A. Press the bushing into a groomer plate until the bushing is centered in
the idler arm bore.
Universal Groomer (Optional): Service and Repairs
Page 8–12
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
