The Height Adjuster Assembly
g285728
Figure 187
1.
Clevis pin
8.
Flange nut
15.
Quick up cover
2.
Cotter pin
9.
Washer (2 each)
16.
Detent spring
3.
Tabbed washer
10.
Compression spring
17.
Button-head screw
4.
Lock nut
11.
Pinch bolt
18.
Height adjuster knob
5.
Bumper
12.
Height-of-cut bracket
19.
Height adjustment bolt
6.
Plow bolt
13.
Quick up lever
7.
Height adjustment rod
14.
Groomer pin
Note:
Early universal groomers used 2 compression springs on non-adjustable
height adjustment rods. Retrofitting the assemblies on each side of the cutting
unit with new compression springs, height adjustment rods, and adding flange
nuts to enable spring adjustment is recommended.
Disassembling the Height Adjuster
1. Remove the cutting unit from the machine.
2. Remove the cotter pins and clevis pins that secure the height adjustment
rods to the groomer gear box and idler arm. Discard the cotter pins.
3. Loosen the pinch bolts that secure the front roller to the height-of-cut
brackets.
4. Remove the hex nuts, tabbed washers and plow bolts that secure the
height-of-cut brackets to the cutting unit side plates, and remove the height
adjusters and front roller from the cutting unit.
5. Disassemble the height adjuster assembly as necessary.
6. Replace components that are worn or damaged.
Assembling the Height Adjuster
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly.
Greensmaster® eTriFlex 3360 and 3370
Page 8–17
Universal Groomer (Optional): Service and Repairs
19239SL Rev B
