Operator Advisories
Operator advisories are automatically displayed by the InfoCenter when a
machine function is prevented and additional action is required. Typically, an
advisory can be eliminated with a change in machine controls by the operator.
For example; if the operator attempts to drive the machine when the manual
parking brake is engaged, an advisory is identified on the InfoCenter Display that
the manual parking brake needs to be in disengaged. An advisory will not be
logged into any fault log. The following table lists each advisory in detail.
Operator Advisories
Advisory
Number
Advisory Name
Cause
InfoCenter Message/Corrective
Action Required
B200A (Model
04580 Only)
START DENIED
Starter has been active
for 30 seconds
Start Denied | Key held too long
B2013 (Model
04580 Only)
START DENIED
Fault(s) Active
Start Denied | Resolve active faults
B201B (Model
04580 Only)
START DENIED
Starter/Generator not ready
Start Denied | Wait for starter
B2024 (Model
04580 Only)
ENGINE RPM
RESTRICTED
Engine Oil Pressure Low
Engine RPM Restricted | Check Oil
B2152
TRACTION
DISABLED
Traction not ready
Traction Denied | Wait for traction
B2155
TRACTION
DISABLED
Parking brake engaged
Traction Denied | Release parking brake
B2159
TRACTION
DISABLED
Out of seat
Traction Denied | Seat
B215A
TRACTION
DISABLED
Traction illegally engaged
Traction Denied | Return pedal to neutral
B215B (Model
04580 Only)
TRACTION
DISABLED
Engine not running
Traction Denied | Start engine
B2162
LIFT/LOWER
CALIBRATION
Lift/Lower actuator 1
(center/rear) not calibrated
Calibrate Lift/Lower 1
B2163
LIFT/LOWER
CALIBRATION
Lift/Lower actuator 2 (left)
not calibrated
Calibrate Lift/Lower 2
B2164
LIFT/LOWER
CALIBRATION
Lift/Lower actuator 3 (right)
not calibrated
Calibrate Lift/Lower 3
B2116A
TRACTION
ADVISORY
Traction pedal position sensor
needs calibration
Calibrate traction pedal
B2116B
TRACTION MOTOR
CALIBRATION
Traction motor not calibrated
Calibrate traction motor
B2116C
STEERING CENTER
CALIBRATION
Steering System – Center
not calibrated
Calibrate steering center
B2116D
STEERING RANGE
CALIBRATION
Steering System – Range
not calibrated
Calibrate steering range
B2300 (Model
04590 Only)
SYSTEM
SHUTDOWN
Battery Fault(s) Active
System Shutdown | Battery fault active
B2301 (Model
04590 Only)
MACHINE DISABLED
Battery charger connected
Machine Disabled | Disconnect charger
B2302 (Model
04590 Only)
LOW BATTERY
Battery Low | Charge battery
B2303 (Model
04590 Only)
BATTERY
OVERLOAD
Battery Overload | Reduce power draw
Greensmaster® eTriFlex 3360 and 3370
Page 3–3
Troubleshooting: Battery Charger Error and
19239SL Rev B
