Removing the Starter/Generator Assembly (continued)
5. Remove the fuel tank; refer to
Removing the Fuel Tank (page 4–4)
.
6. Remove the evaporative control system carbon canister from the machine.
7. Disconnect the electrical system wiring from the engine:
• The engine wire harness connector at the main wire harness (left side of
engine). Check the engine and wire harness connector for damage or
corrosion and clean or repair as necessary.
• The wire harness ground at the engine (near front left engine mount).
8. Disconnect the choke cable from the engine.
9. Remove the clamp securing the engine oil drain hose to the right side battery
tray.
10. Disconnect the starter/generator from the machine wire harness. Check the
starter/generator and the harness connector for damage or corrosion and
clean or repair as necessary.
11. Tilt the operator seat forward and remove the starter/generator pulley cover.
12. Remove the fasteners securing the engine frame assembly to the 3 isolating
mounts.
CAUTION
The engine frame assembly weighs approximately 68 kg (150 lb).
Use an appropriate lift to remove the engine frame assembly.
13. Remove the engine frame assembly from the machine.
14. Loosen the hex nuts and extend the adjustment pin as far as possible to relax
the extension spring. Remove the extension spring from the starter/generator
spring bracket.
g286883
Figure 100
1.
Generator drive belt
5.
Hex nut (2 each)
2.
Generator pulley
6.
Adjustment pin
3.
Engine pulley
7.
Extension spring
4.
Engine frame
8.
Cap screw (4 each)
Electrical System: Service and Repairs
Page 5–122
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
