Rear Traction Motor (Optional)
The optional rear traction motor is attached to the rear wheel gear box cover.
The rear wheel gear box must be removed and disassembled to access the
motor mounting fasteners.
If the rear traction motor is replaced for any reason, the machine software must
be updated; contact an Authorized Toro Distributor for assistance.
g293227
Figure 106
1.
3WD traction motor
6.
Square key
2.
O-ring
7.
Set screw
3.
Gasket
8.
Spur gear
4.
Gear box cover
9.
Socket head cap screw
5.
Socket head screw (6 each)
Removing the Rear Traction Motor
Refer to
for this procedure.
1. Remove and disassemble the 3WD gear box assembly; refer to
Gear Box (Optional 3WD) (page 6–19)
.
2. Remove the 6 fasteners securing the motor to the cover and remove the
motor.
3. Remove and discard the motor gasket and O-ring.
4. Remove the spur gear and square key from the motor shaft if necessary.
Greensmaster® eTriFlex 3360 and 3370
Page 5–133
Electrical System: Service and Repairs
19239SL Rev B
