Front Traction Motor
The front traction motors can be replaced separate from the front traction gear
box. The front traction gear box can be removed or installed before or after the
motor is removed from the machine; refer to
Front Traction Gear Box (page
.
If the front traction motor is replaced for any reason, the traction motors must be
calibrated; refer to
Calibrating the Front Traction Motors (page 5–56)
.
For front traction motor testing information; refer to
Front Traction Motor (page
5–55)
.
g293156
Figure 105
(shown with front traction gear box attached)
1.
Traction motor and gear box
assembly
6.
Shoulder bolt
11.
Thrust washer (6 each)
2.
Button head cap screw (2 each)
7.
Button head screw
12.
Support link
3.
Arm – LH
8.
Washer
13.
Clevis pin
4.
Button head cap screw (2 each)
9.
Extension spring
14.
Cotter pin
5.
Brake lever – LH
10.
Cap screw (6 each)
Removing and Installing the Front Traction Motor
Refer to
for this procedure.
1. Remove the front wheel; refer to
Removing and Installing the Wheels (page
.
2. Unplug the 48V battery; refer to
48V Battery Disconnect (page 5–9)
.
3. Disconnect the multi-pin wire harness connector and the 3 power cables
from the motor. Check the motor, harness connector and cable terminals for
damage or corrosion and clean or repair as necessary.
Greensmaster® eTriFlex 3360 and 3370
Page 5–131
Electrical System: Service and Repairs
19239SL Rev B
