Electric Cutting Unit Motor Adapter
g285260
Figure 162
1.
Hex nut (2 each)
4.
Motor clamp
2.
Motor adapter
5.
O-ring
3.
Socket head screw (2 each)
6.
O-ring (2 each)
Removing and Installing the Cutting Unit Motor Adapter
Refer to
for this procedure.
1. Remove the electric motor from the cutting unit and move it to the storage
location at the front of the cutting unit suspension.
2. Remove the motor adapter from the cutting unit side plate.
Note:
The lock nuts are captured in the back side of the side plate.
3. Remove the large O-ring and the 2 small O-rings from the motor adapter.
Discard the large O-ring.
4. Lubricate a new large O-ring with grease and install in on the motor adapter.
5. Install the 2 small O-rings in the motor adapter without lubrication. Ensure
the O-rings are correctly positioned in the motor adapter grooves.
6. Install the motor adapter to the cutting unit side plate and install the electric
cutting unit motor.
DPA Cutting Units: Service and Repairs
Page 7–22
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
