TEXIO DL-2060, Instruction Manual

Page: 81 / 152

75
How to program each channel with measurement function
Press SHIFT + DIGITS for scanning configuration. Use
◁
and
▷
to scroll
through submenus. Press ENTER on “SET SCAN CHA” submenu. Use
◁
and
▷
to
switch from channel 1 to channel 10
(
or channel 20), and use
△
and
▽
to switch among
the measurement functions. Leave an unused channel with a blank space (----). Press
ENTER when ten channels are all defined. Press ESC to exit from configuration mode.
How to configure scan count, scan interval and store measurement readings
Press SHIFT + DIGITS for scanning configuration. Use
◁
and
▷
buttons to
scroll through submenus. Press ENTER to select “OPERATION” submenu. Use
◁
and
▷
to switch among scan count (COUNT), scan interval (TIMER) and store (STORE) options.
Then press ENTER on your selection. Use
◁
and
▷
to move through the digits and
△
and
▽
to increase or decrease the numbers to a desired value. For STORE option, you
can select ON to instruct the meter to store the measurement results for later retrieving
or select OFF .Press ENTER to set the value.
How to open and close the channels
Press SHIFT + DIGITS for scanning configuration. Use
◁
and
▷
buttons to
scroll through submenus. Press ENTER on “----” when you need to close a specific
channel. Press ENTER again on “CHANNEL”. Use
◁
and
▷
to move through the digits
and
△
and
▽
to increase or decrease the numbers to the desired channel number. Press
ENTER to close the channel. To open all channels, simply press ENTER on “OPEN ALL”
option. Press SHIFT + DIGITS to scan.
The locations of the buttons are shown with red rectangle frames in
Figure 4-31 .
Figure 4-31