57
3.3.2 % (Percent)
Definition
This mathematical function calculates the ratio of a measurement reading to a specified
target value as the form of percentage. The calculation formula is shown below:
The specified target value is store in a volatile memory and will be cleared after the
meter has been turned off or a remote interface reset.
How to use % (Percent) function
There are two ways to make a percent measurement: Through the front panel operation
or through the remote interface operation.
Front Panel Operation
To specify a target value, user needs to configure Percent function by pressing %,
then use
◁
and
▷
to move through the digits and
△
and
▽
buttons to increase or
decrease the numbers to a desired target value. Press ENTER to set the value. Press % to
activate this function. And then observe the calculated percent value on the display as
shown as
Figure 4-15
.
※
Note: Press % again to disable this function. The “MATH” annunciator on the display
indicates the state of a mathematical feature.
Figure 4-15
Remote Interface Operation
Use the following commands to enable and configure Percent function:
CALCulate:FUNCtion PERCent
CALCulate:STATe {OFF|ON}
CALCulate:STATe?
CALCulate:PERCent:TARGet {<
value
>|MINimum|MAXimum}
CALCulate:PERCent:TARGet? [MINimum|MAXimum]
Summary of Contents for DL-2060
Page 37: ...31 Figure 3 17 1 2 3 5 5 4...
Page 136: ...130...
Page 137: ...131...
Page 138: ...132 D DL 2060 s Dimension...
