TEXIO DL-2060, Instruction Manual

Page: 55 / 152

49
3.2.1 Trigger Mode
There are three trigger modes in DL-2060: auto, immediate, and single triggering. User
can specify the trigger mode for their measurement. The factory default is auto
triggering when the meter is power-on.
A. Auto Triggering Mode (Front Panel Operation only)
Definition
Auto triggering takes continuous readings at a fastest rate possible for the present
measurement. The rate of taking readings depends on the current settings. This function
is only available through the front panel. The auto triggering is also the default for
trigger mode in DL-2060.
How to use Auto Trigger
Press ATUO TRIGGER on the front panel to toggle for enabling auto trigger mode. The
location of the button is shown with a red rectangle frame on
Figure 4-9 .
Figure 4-9
B. Internal Immediate Trigger Mode (Remote Interface Operation Only)
Definition
The immediate triggering mode is only available through the remote interface
operations and it is the default for the remote interface operations. When the meter is in
immediate trigger mode, a trigger will be issued immediately as soon as the meter is in
“wait for event” state.
How to use Immediate Trigger
Use the following command in your PC terminal to set the internal immediate trigger.
TRIGger:SOURce IMMediate