81
Default
The default band is 0.1%. The defined selection is stored in a volatile memory and it
will be cleared after the meter has been turned off.
How to enable/disable HOLD feature
1.
Press SHIFT + TRIGGER buttons. The HOLD anunciator will light up when HOLD
feature is enabled as shown in
Figure 3-34
.
2.
To disable HOLD feature, press SHIFT + TRIGGER again.
Figure 3-34
How to adjust the sensitivity band
You can adjust the sensitivity band through the front panel operation.
Front Panel Operation
1.
Do the procedure SHIFT + CONFIG > TRIG SYS > READ HOLD > 0.01% / 0.1% /
1.0% / 10.0% to choose a desired band. Press ENTER on the desired sensitivity
band.
Figure 3-35
