77
Front Panel Operation
Use the following steps to control the display:
1.
Do the procedure SHIFT + CONFIG buttons > SYSTEM > ENTER > DISPLAY >
ENTER > ON/OFF > ENTER to enable/disable the display as shown in
Figure
3-30
.
Figure 3-30
Remote Interface Operation
The following commands show how to control the display as well as how to send a
message to the display:
DISPlay {OFF|ON}
(
turns off or turns on the display
)
DISPlay:TEXT <quoted string
>
(displays the string you type in)
DISPlay:TEXT:CLEar
(clears the message displayed)
3.4.2 Beeper
DL-1060 beeps when some certain conditions are met or when an error occurs. But
there may be time you want to disable the beeper for some operations. Although you
can turn off the beeper, the click sound you hear when a button is pressed will not be
disabled. The beeper state is stored in a volatile memory and the default will be
restored when the meter has been turned off or after a remote interface reset.
By disabling the beeper you will not hear the meter beeps when
:
⚫
A new minimum or maximum is found in Min/Max operation
.
⚫
A stable reading is detected and held
.
⚫
The test voltage is within the limits in diode testing
.
⚫
The source signal fails the limit testing.
