56
Figure 3-15
How to set the Address when using GP-IB
1.
Press SHIFT + CONFIG buttons, and then use
◁
and
▷
buttons to locate
“INTERFACE”. Press ENTER to select it
as shown in
Figure 3-16
.
2.
Use
◁
and
▷
buttons to locate “GPIB”. Press ENTER to select it.
3.
Use
◁
and
▷
buttons to move through the digits and
△
and
▽
buttons to adjust
the numbers to a desired GPIB address. Press ENTER to set the address.
How to set up RS-232C
The RS-232C interface port of DL-1060R uses 9-pin D-sub connector. To connect
DL-1060R/VR to a PC or terminal, you must use
“
InterLink cable
”
. This cable is also
called
“
null-modem cable
”
. If you selected NONE Flow Control, your PC has 25-pin
connector, or etc. Then prepare a proper cable for your configuration. The connecting
diagram is shown below.
How to set the RS-232C configuration
1.
Press SHIFT + CONFIG buttons, and then use
◁
and
▷
buttons to locate
“INTERFACE”. Press ENTER to select it as shown in
Figure 3-16
.
2.
Use
◁
and
▷
buttons to locate “
RS232
”. Press ENTER to select it.
Then use
◁
and
▷
buttons to locate “BAUD RATE”
,
“
DATA BITS
”
,
“
PARITY
”
,
“
STOP BITS
”
, or
“
FLOW CONTROL
”
. Press ENTER to select it