31
2.8.1 Thermocouple Measurements
Connect the thermocouple to the TC INPUT jack on the front panel. The difference
between each type is subject to sensors.
How to measure thermocouple
1.
To measure thermocouple must be via a purposive sensor as shown in
Figure
2-9
.
2.
Press SHIFT + TEMP buttons to select thermocouple measurement.
3.
Configure the thermocouple type by using the CONFIG button (refer to 3.1.8) or
skip this step to use the default settings.
4.
Observe and take readings on the display.
D C V
A C V
F R E Q
N U L L
C O N T
T E M P
S T O R E
DIGITS
TRIGGER
E S C
S H I F T
E N T E R
CONFIG
Figure 2-9
2.8.2 RTD Measurements
There are three kinds of temperature measurements with RTDs: 2-wire, 3-wire and
4-wire measurements. You will find connection instructions and measuring procedures
in the following sections. The source current for the RTD measurement is 1 mA.
