Genie_TS_Series GigE Vision Camera
Operational Reference
69
Falling Edge
FallingEdge Specifies that the trigger is considered valid on the
falling edge of the source signal.
Any Edge
AnyEdge Specifies that the trigger is considered valid on the
falling or rising edge of the source signal.
Output Line Pulse Delay
outputLinePulseDelay
Sets the delay (in µs) before the output line pulse
signal. Applicable for the OutputLineSource
feature. Note, the LineMode feature must be set to
output.
1.00
Beginner
DFNC
Line Pulse Duration
outputLinePulseDuration
Sets the width (duration) of the output line pulse
in microseconds. The LineMode feature must be set
to Output.
1.00
Beginner
DFNC
Output Line Software Latch
Control
outputLineSoftwareLatchControl
When Off, the selected output line is set with the
value in Output Line Value. (RO)
Off
Off Output pin state set by outputLineValue.
Latch
Latch Output pin state set by outputLineSoftwareCmd.
1.00
Guru
DFNC
Output Line Software
Command
outputLineSoftwareCmd
Writing a value of 1 in the bit field applies the
Latch value of the outputLineSoftwareLatchControl
and/or executes the PulseOnSoftwareCmd for any
output line programmed for software control. The
feature outputLineSoftwareCmd can take any
binary value and each bit set to 1 corresponds to a
Icommand for an Output. Note that Outputs are
numbered from 1 to N, therefore Bit 1 of
outputLineSoftwareCmd corresponds to Output1.
This is applicable to OutputLineSource = Pulse On:
where Software Cmd (for Pulse mode) or
OutputLineSource = SoftwareControlled and
OutputLineSoftwareLatchControl = Latch (for static
states).
1.20
Expert
DFNC
outputLineValue
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF.
OutputLineSource must be SoftwareControlled. If
the outputLineSoftwareLatchControl = Latch , the
state of the pin will change with the
outputLineSoftwareCmd command.
Active
Active Sets the Output circuit to close
Inactive
Inactive Sets the Output circuit to open
1.00
Beginner
DFNC
