98
Operational Reference
Genie_TS_Series GigE Vision Camera
Cycling Preset Mode Control Category
The Genie TS Cycling Preset controls, as shown by CamExpert, groups parameters used to
configure the camera Cycling features. Cycling controls allow the user to configure a number of
camera operational states and then have the camera automatically switch between states in real-
time. Only the features programmed to change are updated when switching between camera
states, thus ensuring immediate camera response. A setup example follows the feature table.
Parameters in gray are read only, either always or due to another parameter being disabled.
Parameters in black are user set in CamExpert or programmable via an imaging application
Features listed in the description table but tagged as
Invisible
are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications. Also important, Genie
TS cameras are available in a number of models implementing different sensors and image
resolutions which may not support the full feature set defined in this category.
