Tecnoalarm TP8-64 BUS, Installer Manual

Page: 188 / 246

Control by console Installer Manual - TP8-64 BUS
6-12
6.4 ACTIVATION/DEACTIVATION REMOTE
CONTROLS
The master programming menu permits the manual activation and deactivation of the
remote controls.
Enter the master code (default 12345)
+
12345
master code (default)
+
yw
to select the remote controls menu
+
yw
to select the remote controls to activate/deactivate
Commands available
+
#
to activate the remote control
+
*
to deactivate the remote control
+
EXIT to confirm and quit
QUICK ACTIVATION/DEACTIVATION (IF ENABLED)
If the quick menu of the consoles is enabled, the manual activation and deactivation of
the remote controls without code is possible.
+
yw
to select the remote controls to activate/deactivate
+
#
to activate the remote control
+
*
to deactivate the remote control
+
EXIT to confirm and quit
6.5 MANUAL COMMUNICATOR BLOCK
During an alarm call, it is possible to block the communicator, i.e. interrupt the active
alarm call cycle and thos waiting to be executed.
Enter the Master code (or a user code) enabled for the manual communicator block,
and press
EXIT , e.g.:
+
12345
EXIT
On the display is viewed Abort Telephone ? * NO # YES.
Commands available
+
#
to block the communicator
+
*
to abandon and quit
Menu 1
Remote ctrl
Remote ctrl 1
Remote ctrl 01
Rem. ctrl 01 1
Activation
[ # ]
Abort telephone ?
* NO # YES
WARNING
The block of the telephone calls is only permitted with master code or one of the standard user
codes (1 to 62).
The blocking command stops all the active alarm calls cycles as well as those waiting.
The block of the telephone calls is not permitted in case of hold-up alarm. In this case, the cycle
continues uninterrupted.