Tecnoalarm TP8-64 BUS, Installer Manual

Page: 175 / 246

TP8-64 BUS - Installer Manual Programming by console
5-37
5.21.5 VIEWING OF THE FIRMWARE VERSION
On initiation, on the display is viewed the release and the language of the firmware of
the control panel.
Commands available
+
EXIT to quit the submenu
5.21.6 VIEWING OF THE VOCABULARY VERSION
On initiation, on the display is viewed the release and the language of the vocabulary
of the control panel.
Commands available
+
EXIT to quit the submenu
5.21.7 VIEWING OF THE LED STATUS
On initiation, all the LED on the console are lit and the buzzer is activated.
Commands available
+
EXIT to quit the submenu
5.21.8 GSM MODULE TEST
On initiation, on the display is viewed in sequence:
z
The status of the GSM telephone communicator
z
The GSM signal power:
*
insufficient
** bad
*** reasonable
**** good
***** optimum
z
The firmware version of the GSM telephone communicator
Commands available
+
EXIT to quit the submenu
Test 5
Version
(c) Tecnoalarm
TP64B v.1.0 ENG
Test 6
Vocal synthesis
(c) Tecnoalarm
Vocab. v.2.0 ENG
Test 7
LED console
LED console
Test 9
GSM
GSM
Device OK
GSM
Signal
*****
GSM
Ver. 1.5
WARNING
During the test, the GSM telephone communicator must be connected to the control panel through
the serial line.