Tecnoalarm TP8-64 BUS, Installer Manual

Page: 168 / 246

Programming by console Installer Manual - TP8-64 BUS
5-30
Options 8
Rpt. loc. msg [ ]
Options 9
Volume low [ ]
Options 10
Key sin. arm. [ ]
Options 11
Inv.dig.prot. [ ]
Options 12
Modif. codes [ ]
Options 13
Radio mode [ ]
Options 14
Tamper [ ]
Options 15
AM Zones [ ]
z
Rpt.loc.msg Enabling of sound report.
Enables the console for playing back voice messages
describing all the operations being executed and events
occurring.
[ # ]
Sound report enabled
z
Rpt.loc.msg Enabling of sound report.
Enables the console for playing back voice messages
describing all the operations being executed and events
occurring.
[ # ]
Sound report enabled
z
Key sin. arm. Single arming by key.
Enables the keys for single arming only (relevant for key
readers connected to key interface only, not valid for key
readers with minikeypad), even if they are enabled for several
programs. On every introduction of the key into the key reader
a different program is armed.
[ # ]
Arming by key singlularly only
z
Inv.dig.prot. Inversion of digital protocols.
Permits the inversion of the figures sent during digital
transmissions.
[ # ]
Inversion of the digital protocols
z
Modif. codes User code modification.
Permits enabling/disabling of the modification of the standard
user codes by the holder of the codes themselves. If the user
code modification is disabled, merely the holder of the master
will be entitled to change the standard user codes. If it is
enabled, the user will however only be entitled to change its
own code and in no case that of the other users.
[ # ]
User code modification enabled
z
Radio mode Wireless transmission mode.
Every wireless transmission mode a different transmission
power of the wireless receiver-transmitter (RTX200/433868) is
assigned:
•
System 1
• System 2
• System 3
z
Tamper Defines the tamper control mode:
•
Counter (i.e. number of zone openings 1 to 255)
Defines the number of alarm cycles after which the tamper
is automatically excluded.
• Timeout (hours : minutes)
Defines the period of time between the self-eclusion of the
tamper and the automatic reactivation of tamper.
z
AM Zones Enabling of antimasking alarm zones.
Defines the antimasking control mode:
•
Always active
• Al. if P armed
• If P armed
Viewing of the current settings
[ ] Option not enabled
[ # ] Option enabled
Commands available
+
#
YES to enable the option selected
+
*
NO to disable the option selected
+
EXIT to accept programming and quit the submenu