Tecnoalarm TP8-64 BUS, Installer Manual

Page: 229 / 246

TP8-64 BUS - Installer Manual Special procedures - Appendix B
B-3
B. SPECIAL PROCEDURES
B.1 RESET OF THE DEFAULT CODES
When the control panel is in stand-by (date and time viewed), to reset the default
codes, procede as follows:
z
Insert the jumper JP2.
z
When Line ! ABSENT! is viewed, press the EXIT key several times.
On the display is viewed Code Deleted .
z
Remove the jumper JP2.
After few a seconds, the control panel returns to stand-by and on the display
reappears date and time signaling.
B.2 COMPLETE DELETION OF SYSTEM
CONFIGURATION (RESET OF DEFAULT SETTINGS)
When the control panel is in stand-by (date and time viewed), to reset the default
configuration, procede as follows:
z
Insert the jumper JP2.
z
When Line ! ABSENT! is viewed, press the star key
*
NO several times.
On the display is viewed Config. Deleted .
z
Remove the jumper JP2.
After a few seconds, the control panel returns to stand-by and on the display
reappears date and time signaling.
Line
! ABSENT !
Code
Deleted
Tue 19 JUN 07
Work. 10 : 45
Tue 19 JUN 07
Work. 10 : 45
WARNING
The reset of the default codes will affect all the codes of the system as well as the code length:
z
Default installer code 54321
z
Default master code 12345
z
Default standard user codes 00000 (unvalid code)
z
Default code length 5 digits
WARNING
After the deletion of the system configuration, the control panel will be set with all the default settings
(i.e. no telephone number, no zone configuration, no function programmed) and the default codes as
as well as the default code length:
z
Default installer code 54321
z
Default master code 12345
z
Default standard user codes 00000 (unvalid code)
z
Default code length 5 digits
Line
! ABSENT !
Config.
Deleted
Tue 19 JUN 07
Work. 10 : 45
Tue 19 JUN 07
Work. 10 : 45