Tecnoalarm TP8-64 BUS, Installer Manual

Page: 153 / 246

TP8-64 BUS - Installer Manual Programming by console
5-15
5.9.5 PROGRAMMING OF THE BUS SIRENS
Permits the selection of the bus sirens (from 1 to 4) and define functioning of each
siren.
Commands available
+
yw
to select the siren
+
#
YES to confirm the selection
Submenu
z
Program Permits the association of the bus siren selected to the
programs of the control panel (1 to 8).
z
After blinking Defines the time blinking is to continue (in minutes) once the
alarm has been stopped.
z
Volume signaling Defines the sound level signaling (low, medium low, medium
high, high)
z
Siren mode Two modes available:
•
Indoor siren
Functioning mode, time and tipical sound of indoor siren
• Outdoor siren
Functioning mode, time and tipical sound of indoor siren
z
Alarm The siren is actived if at least one of the programs it is
associated to is in alarm (observing the relative time settings)
and in case of general alarm (tamper, trouble etc.).
Sound type available:
•
Sound 1 Bidirectional sweep tone (default setting)
• Sound 2 Monodirectional sweep tone
• Sound 3 Bitone
z
Technical alarm The siren is actived if the technical zone in alarm is not
included in any program at all or if it is included in one of the
programs the siren is associated to.
Sound type available:
•
Sound 1 Bidirectional sweep tone (default setting)
• Sound 2 Monodirectional sweep tone
• Sound 3 Bitone
z
Prealarm The siren is actived in case of prealarm of at least one of the
programs it is associated to.
The sound type is fixed.
z
Signaling The siren is actived in case of arming/disarming of the
programs it is associated to.
The sound type is fixed.
z
Chime The siren is actived if the chime zone opened is not included
in any program at all or if it is included in one of the programs
the siren is associated to.
The sound type is fixed.
z
Attributes • Enabling antifoam
• Enabling antidrilling
z
Activation mode Determines the activation mode of the siren for the events
detected by the control panel:
•
Not active The siren is not activated at all
• Sounding Only sounding is activated
• Flashing light Only flashing light is activated
• So Flashing light Sounding and falshing light
are activated
Viewing of the current settings
[ ] Function disabled
[ # ] Function enabled
Commands available
+
yw
to select the function
+
#
YES to select and activate the function
+
*
NO to deactivate the function
+
EXIT to confirm and quit the submenu
Bus sirens 1
Siren 01
Siren 01 1
Programs
Programs 1
Program 01 [ # ]