Tecnoalarm TP8-64 BUS, Installer Manual

Page: 99 / 246

TP8-64 BUS - Installer Manual Programming by PC
4-5
DETECTOR
Permits association and configuration of the detector or contact by clicking on the correspondent item:
Technology
Determines the kind of detector or contact:
z
Dual technology
z
Contact
z
Barrier
z
Microwave
z
Inertia
z
24H
z
PIR
z
Pulse count
z
RDV
Type
Permits the selection of the modell of the device.
Filter
Determines the response time or sensitivity according to the kind of the detector or contact selected.
PROGRAMMING OF A DEVICE CONNECTED VIA ZONE BUS
Type
Select the type from the devices listed (WINBEAM/S from 2 to 5 beams - DOORBEAM/S from 6 to 8 beams).
Beams
Permits enabling/disabling of determined beams (the flag indicates that the beam has been enabled).
Position cable
Permits the selection of the cable position (top/bottom).
Response time
Permits programming of the response time (T) of the device at two levels (0.2 seconds or 0.5 seconds).
Functioning mode
Permits the definition of the modality of alarm detection:
z
1 for 1 sec. or 2 adj. for T
The alarm is released if any beam is interrupted for 1 second or two adjacent beams for the response time (T)
programmed.
z
2 adj. for T
The alarm is released if two adjacent beams are interrupted for the response time (T) programmed.
z
3 adj. for T lower part or 2 adj. for T
The alarm is released if three adjacent beams in the lower part of the barrier or two adjacent beams are
interrupted for the response time programmed.
z
1 for T
The alarm is released if any beam is interrupted for the response time programmed.
Power
Permits programming of the beam power at four levels (off, low, medium, high).
Repeat the procedure for every zone to be configured (max. 64), then press:
z
OK to confirm and quit
z
Abandon to quit without saving