Tecnoalarm TP8-64 BUS, Installer Manual

Page: 204 / 246

Control by keypoint
Installer Manual - TP8-64 BUS
7-12
7.4.3.3 DEACTIVATION OF BY-PASS WITH CODE
Enter a code enabled for by-pass (master or standard user code enabled for the programs armed) followed by the
number of the program to be reactivated in its integrity, e.g.:
+
66778
+
1
The LED of the program previously partset becomes lit.
7.4.4 SPECIAL OPERATING CONDITIONS
7.4.4.1 FALSE CODE ALARM
The alarm is released when 32 keys are pressed without entering a valid code.
In case of false code alarm, the red LED 6 general alarm starts blinking.
The keypad which the false code has been entered on is disabled for 2 minutes. Simultaneously, the buzzers of all
the consoles connected are activated and the OCG and key LED of all the key readers and consoles are blinking. To
stop the alarm introduce a valid key or enter a valid code (master or standard user code) on another control unit
connected.
7.4.4.2 SIMULTANEOUS ARMING BY SEVERAL CONTROL UNITS
During the arming process by console, all the electronic keypads are disabled.
When trying to arm the control panel in this situation by electronic keypad, the 3 LED on the keypad blink for
approximately 3 seconds.
7.4.4.3 AUTOMATIC COMMUNICATOR BLOCK
If enabled by the holder of the master code, on disarming of a program the active telephone channels are blocked
automatically.
7.4.4.4 GENERAL ALARM
If a general alarm is active (the corresponding LED is blinking), arming of the control panel is not permitted with code
unless the code is enabled for the by-pass of the general alarms.
WARNING
Outside the access periods associated the codes are not accepted by the control panel and any
attempt at acceding to the system will have no effect.
When trying to do so, the system ignores the command.
The green LED 5 remains lit and the red program LED remain off.
After 5 seconds, the electronic keypad returns to stand-by.
WARNING
It is possible to use only one control unit at a time.