Tecnoalarm TP8-64 BUS, Installer Manual

Page: 158 / 246

Programming by console Installer Manual - TP8-64 BUS
5-20
MENU
13 13 13 13 13
5.13 CONFIGURATION OF THE WIRELESS KEYS
+
yw
to select the menu (13)
+
#
YES to confirm the selection
The control panel provides up to 32 wireless keys with three function keys each. The
wireless keys can be programmed individually so as to execute different functions.
SELECTION OF THE WIRELESS KEY
+
yw
to select the wireless key (from 1 to 32)
+
#
YES to confirm the selection
Submenus
z
Periods Defines the access period (from 1 to 8) during which the
wireless key is enabled
z
Ass. buttons Permits the association of the following functions to the 3
function keys:
•
Disarming (of all the programs that have previously been
armed by the wireless key)
• Arm. program (a determined program from 1 to 8)
• Dis. program (a determined program from 1 to 8)
• ON/OFF rem ctrl (a determined remote control from 1 to 8)
• ON rem ctrl (a determined remote control from 1 to 8)
• OFF rem ctrl (a determined remote control from 1 to 8)
z
Attributes • By-pass
Defines whether the wireless keys is to be used for arming
and disarming or activation and deactivation of by-pass. If
the attribute is selected, the function of the arming and
disarming keys change as follows:
ƒ
Arm. program becomes activation of by-pass of the
program
ƒ
Dis. program becomes deactivation of by-pass of the
program
ƒ
Disarming becomes general deactivation of by-pass
• Conf. dis (confirmation of disarming)
If the attribute is selected, disarming by wireless key
releases a hold-up alarm unless it is confirmed by entering
a valid code within the delay programmed (see
programming of time parameters). If the code is entered
either not at all or late, a silent hold-up alarm is released
and the outputs programmed are activated.
• Autom. abort (automatic communicator block on disarming)
If the attribute is selected, upon disarming by wireless key
all the active telephone channels as well as those waiting
to be activated are blocked.
• Byp gen. al. (by-pass general alarms)
Permits the by-pass of the general alarms, i.e. arming in
the presence of the following alarms: tamper, low battery,
power failure, supervision, trouble
• Duress
Enables the release of a panic alarm by pressing the keys
2 and 3 of the wireless key simultaneously.
• Excl. disab.
Disables both the voluntary exclusion of zones and the
automatic exclusion of open zones. If the control panel is
armed in the presence of open zones, these will release an
alarm at the end of the arming phase.
z
Learning See § 5.13.1
z
Ext. siren If enabled, on arming of the control panel, at the end of the
exit time, the siren is actived for a few seconds (1 impulse).
Viewing of the current settings
[ ] Attribute has not been associated to the wireless key selected
[ # ] Attribute has been associated to the wireless key selected
Menu 13
WL keys
WL keys 1
Periods
WL keys 4
Learning
WL keys 2
Ass. buttons
WL keys 3
Attributes
WL keys 5
Ext. siren