Tecnoalarm TP8-64 BUS, Installer Manual

Page: 152 / 246

Programming by console Installer Manual - TP8-64 BUS
5-14
z
Alarm
The buzzer sounds during the alarm time.
z
Warn. by-pass (end-of-by-pass warning)
The buzzer sounds while the end-of-by-pass warning is displayed.
z
Warn. autom.
The buzzer sounds while the warning of imminent automatic arming (by timer) is
displayed.
z
Sound report (enabling of the sound report)
For each of the above warnings the corresponding voice message is sent out.
Viewing of the current settings
[ ] Buzzer not associated to the parameter selected
[ # ] Buzzer associated to the parameter selected
Commands available
+
yw
to select the parameter
+
#
YES to enable the buzzer for the parameter selected
+
*
NO to cancel a possible existing association
+
EXIT to accept programming and quit the submenu
5.9.4 CONFIGURATION OF THE PROGRAMMABLE OUTPUTS
Permits the definition of the meaning and the stand-by status of the programmable
logic outputs of the system, i.e. CPU board and input expansions (1 to 14) connected.
Commands available
+
yw
to select the module
+
#
YES to confirm the selection
Submenu (options available for every module)
z
Out1 + Programming of the meaning of the logic output OUT1
z
Out2 - Programming of the meaning of the logic output OUT2
z
Out1+ inv. Programming of the logic output OUT1 with reverse stand-by
status
z
Out2- inv. Programming of the logic output OUT2 with reverse stand-by
status
Commands available
+
yw
to select the option
+
#
YES to confirm the selection
5.9.4.1 PROGRAMMING OF THE STAND-BY STATUS
According to programming, the logic outputs have the following stand-by status:
Normal condition Reverse condition
OUT1+ Stand-by: high impedance Stand-by: +13.8V
Alarm: +13.8V Alarm: high impedance
OUT2- Stand-by: high impedance Stand-by: 0V
Alarm: 0V Alarm: high impedance
Viewing of the current settings
[ ] Normal stand-by status
[ # ] Reverse stand-by status
Commands available
+
yw
to select the stand-by status
+
#
YES to activate the reverse stand-by status
+
*
NO to deactivate the reverse stand-by status
+
EXIT to accept programming and quit the submenu
5.9.4.2 PROGRAMMING OF THE MEANING OF THE LOGIC OUTPUTS
According to programming, the logic outputs assume the following meanings:
z
Stand-by
z
Access denied
z
Program 1
z
Fault
z
Alarm
z
Program 2
z
Low battery
z
System OK
z
Program 3
z
Power failure
z
Status mobile
z
Program 4
z
Tamper
z
Remote control 1
z
Program 5
z
Trouble
z
Remote control 2
z
Program 6
z
Hold-up
z
Remote control 3
z
Program 7
z
Technical alarm
z
Remote control 4
z
Program 8
z
Chime
z
Remote control 5
z
Panic
z
Cut telephone line
z
Remote control 6
z
Indoor siren
z
Prealarm
z
Remote control 7
z
Outdoor siren
z
PGM
z
Remote control 8
Commands available
+
yw
to select the meaning
+
#
YES to confirm the selection
Buzzer 5
Warn. by-pass [ ]
Buzzer 6
Warn. autom. [ ]
Buzzer 4
Alarm [ ]
Buzzer 7
Sound report [ ]
Programmable 1
Cntrl panel
Cntrl panel 1
Out1+