Tecnoalarm TP8-64 BUS, Installer Manual

Page: 120 / 246

Programming by PC Installer Manual - TP8-64 BUS
4-26
Programs or remote controls associated
To associate the timers to the programs or remote controls
press the key below the number key. The number of the
access period will be viewed as a confirmation of the
association. It is possible to associated max. 8 programs to
each timer.
Repeat the procedure for every timer to be configured.
TEST CALL CONFIGURATION
Permits the remote functioning check of the control panel. It
consists in one or several telephone calls made by the
channels the test call is associated to (see report codes) to the
telephone numbers programmed.
The calls are made at a determined time with a programmed
frequency.
To enable the test call check the relevant item.
The following parameters can be set for every timer:
z
Hour of activation
z
Frequency of activation
z
Condition
Starting hour of the test call cycle
To program the starting hour of the test call cycle, select the
item next to
Start and enter the time (hh:mm).
Frequency
To program the test call frequency select the item Frequency
and enter a value from 1 to 255.
Then select the unit of the intervall between a test call and the
next (i.e. minutes, hours or days).
Condition
The test call cycle can be bound to system status, i.e. it can
always be executed or only if the control panel is armed.
Select the item
Condition and subsequently the condition of
execution requested (i.e. always or armed).
Once you have finished programming of the timers and the
test call cycle, press:
z
OK to confirm and quit
z
Abandon to quit without saving