Suzuki Samurai 1986, Service Manual

Page: 318 / 482

15-7. REASSEMBLY
NOTE:
l
Make certain that rollers inside spider bearing
race are all in place.
l
Make sure to apply SUPER GREASE C
(99000-25030) to spider bearing race.
Fig. 15-15
In reassembly, be sure to use new circlips,
spider and bearings. Reuse of circlips,
spider and bearings once reassembled is
prohibited
Fig. 15-16
1) Insert bearing race into yoke, tapping it with
a hammer, until it is flush with yoke face.
When doing this, insert spider into bearing
race to prevent rollers in bearing race from
coming out.
Fig. 15-17
1. Copper hammer
2. Bearing race
3. Yoke
4. Spider
2) Insert the other bearing race on the opposite
side into yoke, tapping with a hammer until
it is flush with yoke face.
3) Insert bearing races on the flange yoke side in
the same way as described in 1) and 2) above.
Fig. 15-18
4) Place a metal plate on bearing races when
tapping them in to avoid damaging yoke.
5)Securely fit 4 circlips to shaft and flange
yoke.
NOTE:
l After reassembly, check to ensure that both
shaft yoke and flange yoke move smoothly.
l
Make sure that each circlip is fitted in the
groove securely.
15-7