Suzuki Samurai 1986, Service Manual

Page: 218 / 482

Generator (Pickup
coil) resistance
130 190 ohms
I
1
1. White wire
2. Red wire
Fig.
5. After checking, connect red and white wires
to ignitor as shown in Figure 8-15, and then
install dust cover.
NOTE:
NEVER connect red and white wires reversely.
Reverse connection may cause damage to
generator and ignitor.
1. White wire
2. Red wire
3. lgnitor
4. Generator
Fig. 8-15
6. After generator has been assembled
on
distributor, make sure to adjust air gap and
install ignitor.
7. Install distributor referring to page 8-11.
[ Ignitorl
1. Disconnect negative cable at battery. Remove
distributor, and then ignitor and generator.
2. Remove dust cover from ignitor.
3. Disconnect red and white wires from ignitor.
4. Connect an ohmmeter, a bulb and 12 voltage
battery to ignitor as shown in Figure 8-16.
Set ohmmeter at 1 ohm to 10 ohm range.
Then bring ohmmeter negative prod to
touch red wire terminal of ignitor, and
positive prod to touch white wire terminal.
If bulb is illuminated, it indicates that ignitor
is satisfactory. If not, replace ignitor.
NOTE:
l
Never connect battery positive and negative
wires reversely. Reverse connection may cause
damage to ignitior.
l
Under no circumstances should ohmmeter be
connected reversely.
l
Be sure to perform this ohmmeter check
within a short time (two to three seconds).
1
1. lgnitor
5. Negative prod
9. Black/White wire
2. Bulb
6. Red wire terminal
10. Brown wire
3. Ohmmeter
7. Positive prod
11. Earth
4. Battery
8. White wire terminal
Fig. 8-16
Bulb
Tester
L - - - - - - - - - - - -
Fig. 8-17
8-7