Suzuki Samurai 1986, Service Manual

Page: 271 / 482

5) Remove circlip retaining the reverse synchro-
nizer hub on main shaft.
Fig.
6) Remove reverse synchronizer hub, reverse
gear and reverse gear needle bearing.
Hydraulic press
Bush
Fig. 13-17
8) Remove ball and main shaft (center) bearing
by using hydraulic press.
NOTE:
In the state as shown below, there is a ball in
washer which is located under bearing. Be sure
to prevent it from falling off and getting lost.
Hydraulic press
Fig. 13-16
Fig. 13-18
7) Remove bearing washer and reverse gear
bush on main shaft by using hydraulic press.
NOTE:
During this removal, watch out for a ball which
may fall off. It must not be lost. Also, ball
bearing should not be removed together with
above washer and bush.
9) Remove low gear, needle bearing, synchro-
nizer ring and spring on main shaft.
Fig.
13-9