Suzuki Samurai 1986, Service Manual

Page: 363 / 482

Installation Instruction
After removing front axle shaft drive flange,
install parts (shown in below figure) in accor-
dance with the following procedure.
Cone washer
Gasket “A”
Cover
\
Clutch
Fig. 17-5-3
1) After aligning mark on the knob of
free wheeling hub cover with “FREE” posi-
tion, separate free wheeling cover ass’y from
body ass’y .
2) To facilitate installation, apply sealing com-
pound 366E (99000-31090) thin.
Fig. 17-5-4
3) Install gasket “A” and free wheeling hub
body ass’y on front wheel hub.
N.m
kg-m lb-ft
Tightening torque
.
20 30 2.0 3.0 14.5
21.5
Fig. 17-5-5
4) Put bolt into front axle shaft and pull out
the shaft and fit snap ring in the groove of
axle shaft.
Remove bolt
from axle shaft.
3 . B o l t (a)
Fig. 17-5-6
5) Install cover ass’y to body ass’y so that
follower stopper nail is fitted into groove of
body ass’y.
NOTE:
Before installing cover ass’y, make sure of
following points.
l
mark on knob is at “FREE” position.
l
Clutch is lifted to the cover side, if not
(shown in below figure) it may cause malfunc-
tion.
l
Gasket is set justly.
, Cover
Fig. 17-5-7
17-28