Suzuki Samurai 1986, Service Manual

Page: 129 / 482

Connect electric couplers securely.
l
Connect accelerator cable to carburetor. With
the accelerator pedal released, adjust the cable
play to specification. This adjustment can be
made by turning the adjusting nut. After
adjustment, tighten the lock nut. Refer to
4-19.
l
Connect vacuum hoses securely.
l
Refill cooling system.
l
Connect negative cable at battery.
NOTE:
Upon completion of installation, be sure to
check each part for evidence of fuel leakage and
for proper operation. If defective, correct.
.
UNIT REPAIR OVERHAUL
This section outlines procedure to be used for
overhauling carburetor as removed from engine.
For removal and installation of carburetor from
and to engine, refer to the previous page.
NOTE:
l
Be sure to replace gaskets as well as worn or
damaged parts.
l
While disassembling and assembling carbure-
tor, use special care not to deform levers on
throttle valve shaft or cause damage to any
other parts.
l
Don’t disassemble mixture control solenoid
valve and accelerator pump piston.
l
Don’t remove idle and wide open micro
switches from the bracket where they are
installed.
Disassembly
1) Turn fast idle cam counterclockwise and
insert a pin avialable into holes on cam and
bracket to lock the cam.
Fig. 19
1. Fast idle cam
2. Bracket
3. Pin
4-13