Stryker 6392, Operation Manual

Page: 24 / 866

F Fiig gu urre e 5 5 –– P Pe errffo orrm ma an ncce e--L LO OA AD D a alliig gn nm me en ntt
2. If you are not planning to install the floor plate caps, skip to step 6.
3. To install the floor plate caps, measure the exposed pocket at the head end and the foot end of the floor plate to
customize the floor plate cap, which is included with the floor plate assembly kit (6390-009-020). See Installing the floor
plate (page 10).
N No otte e -- It is recommended that you add an additional 1 in. (2.5 cm) to the floor plate cap at the foot end to allow for
overlap with P Pe errffo orrm ma an ncce e--L LO OA AD D.
4. Using a hack saw, cut two pieces of the floor plate cap to fit the measured length on both ends. The floor plate cap does
not fit over the cleat. To cover a cleat, cut or remove the vertical tabs where they may interfere with the cleat (Figure 6).
F Fiig gu urre e 6 6 –– C Cu utt ffllo oo orr p plla atte e cca ap pss
5. Using a rubber hammer, snap each floor plate cap into the floor plate (hook side first).
N No otte e -- To unsnap the floor plate cap, use a slotted screwdriver on the side of the cover with a raised edge.
6. If your system is not equipped with inductive charging, skip to step 12.
7. If your system is equipped with inductive charging, follow steps 8-11.
8. Lay the excess wire into the floor plate pocket. Align the four holes with the mounting holes in the cleats.
C CA AU UT TIIO ON N -- Always place the wire inside the floor plate pocket, so the fastener assembly does not pinch the wire when
you install the fastener assembly.
9. Connect the red and black wires from the fastener assembly to the anchor-to-vehicle cable (6390-001-135). Connect the
red wire from the fastener assembly to the red wire on the anchor-to-vehicle cable. Connect the black wire from the
fastener assembly to the black wire on the anchor-to-vehicle cable. Feed any excess wire through the electrical rubber
grommet.
EN 20 6392-009-005 Rev F.1