Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual

Page: 174 / 327

Operation
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 174
6.2.3.10 Reverse transport floor
Risk due to failure of components caused by frequent or long
reverse of transport floor!
Observe the fact that the feed direction of the transport floor is only
allowed to be reversed for a short time (max. 3 seconds).
Check the transport floor chains for proper tension every day, in order
to prevent material damage.
Reverse:
•
only for a short time,
•
only in case of emergency,
•
if the slip clutch responds during discharge or
•
in order to reduce the pressing power which the loaded
material applies to the beaters.
1.

Press the soft key to switch the transport floor feed off.
2.

Press the key
The transport floor starts running and conveys the loaded material away from the beaters for a
maximum time of 3 seconds.
6.2.3.11 Switch automatic charging system on/off
Switch the automatic charging system on for uniform and complete
filling of the cargo space.
The automatic charging system:
•
has to be switched on only once,
•
automatically and infinitely variably switches the transport floor
on and off during charging,
•
will automatically be deactivated if the control set generates the
acoustic signal (horn sound) and the visual signal "Forage
wagon full",
•
will automatically be activated if the machine has been emptied
and the pick-up is lowered the next time,
•
remains switched on until the automatic charging system is
manually switched off,
•
permits to pre-select the filling degree of the loaded material in
the cargo space.
The higher the set filling degree, the lower the transport floor feed
rate and the higher the filling quantity.