Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual, Page: 259 / 327

Service and maintenance of machine
259 Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18

Unscrew the counter nut.

Remove the bolt (4) to loosen the
upper link fork from the receiver pipe
(5).

Turn the respective upper link fork to
set the distance between the cutting
knives and the rotor.
•
Increase distance between
cutting knives and rotor =
Shorten upper link = Turn
upper link fork clockwise.
•
Reduce distance between
cutting knives and rotor =
Lengthen upper link = Turn
upper link fork
counterclockwise.
Fig. 121

Measure again the distance on the
right-hand and left-hand side of the
rotor to check the set distance.

Fix the upper link fork to the receiver
pipe by means of the bolt if the
distance between cutting knives and
rotor has been properly set.

Tighten the counter nut.
6.

Reset the bracket (6):

Unscrew the screws (7).

Completely retract the cutting unit.

Push the bracket (6) as far as it will
go below the knife mount (8).

Tighten the screws (7).
Fig. 122