Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual

Page: 216 / 327

Use of machine
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 216
Before charging the machine:
•
check the set operating height of the pick-up and readjust if
necessary, see chapter "Set operating height",
•
check whether the desired cutting length of the loaded material
can be achieved by means of the number of mounted cutting
knives, see chapter "Set cutting length".
When charging the machine, it is imperative to observe the following
information:
•
Only lift the pick-up with the conveyor duct being empty!
•
Reduce the tractor engine speed during cornering!
•
Switch the p.t.o. shaft off and lift the pick-up when taking tight
curves!
•
Avoid uneven charging of the machine which might cause
overloading of the drawbar!
•
Switch the automatic charging system on for uniform and
complete filling of the cargo space.
The automatic charging system:

has to be switched on only once,

automatically and infinitely variably switches the
transport floor on and off during charging,

will automatically be deactivated if the control set
generates the acoustic signal (horn sound) and the
visual signal "Forage wagon full",

will automatically be activated if the machine has been
emptied and the pick-up is lowered the next time,

remains switched on until the automatic charging system
is manually switched off.
•
Pre-select the filling degree of the loaded material in the cargo
space. Observe the information in the chapter "Pre-select filling
degree of loaded material in the cargo space".
•
Observe the visual and acoustic signals of the control set
during charging.
•
Observe the maximum admissible load capacity of the
machine.