Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual

Page: 156 / 327

Operation
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 156
6.1.4.1 Call up SET menu
(1) Arrow
(2

Only for machines equipped with beaters:
Entry of time during which the transport
floor shall reverse if the "Forage wagon
full" switch is switched on when starting
Discharge Mode A II .
(3

Only for machines equipped with beaters:
Entry of time during which the tailgate
shall be activated after reaching the
sensor "First opening width"
The screen shows:
(4

Crossover conveyor display:

An arrow indicates the direction in which the crossover conveyor starts to run

"X" indicates that a crossover conveyor is not available

"W" indicates that the Wollschläger hydraulic system is used
(5

Display of potentiometer position:

Value from 0 to 100

"KAL" appears during the calibration procedure
(6

Left: Display of current software version
Right: Entry whether equipped with
beaters or not; here "with beaters"
(7

Entry of steering axle model
(8

Vacant
(9

Display of total number of service hours
1.

Press and hold the key once. After switching to the SET menu, the arrow (1) is at the top
and is pointing to the right. Now the right-hand functions 2 to 4 can be selected.
2.

Briefly press the key to move the arrow down.
3.

Press and hold the key such that the arrow is pointing to the left
Now the left-hand functions 6 to 7 can be selected.
4.

Use the and keys to change the values by 0.1.
5.

Press the key once.
The Working menu appears.