Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual

Page: 297 / 327

Remedy of malfunctions
297 Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18
The displays of all functions do
not show a status message on
the control set Defective wiring (short-circuit) Check wires, replace them if
necessary
Sensors not properly set Adjust sensors
Defective sensor/s Replace sensor/s
Automatic charging system
switches too late Range not set Recalibrate automatic charging
system
Interrupted hydraulic oil
circulation Switch hydraulic oil circulation
between tractor and machine on
System does not work Malfunction in the system Restart system
Discharge mode A I does not
switch Steering axle not completely
locked due to blocked wheels Move machine slightly forward
9.3.1 Meaning of error messages with ISOBUS control
BM Basic module
EM Extension module
Power Power supply, e.g. of the solenoid valves
Sen. 12V Power supply of sensors
9.4 List of malfunctions, working
Malfunction Cause Remedy
Blockages in the taking-in area Unequal or too large swathes Pick up smaller, more equal
swathes
Excessive travelling speed Reduce travelling speed
Too little flow in the taking-in
area Keep to hitching height
Response of overload clutch
during charging Excessive travelling speed Reduce travelling speed
Blunt cutting knives Sharpen/Replace cutting knives
Loaded material too heavily
compressed Switch transport floor feed
function on in good time
Bad cutting quality Blunt cutting knives Sharpen/Replace cutting knives
Cutting unit extended not far
enough Clean and completely extend
cutting unit
Swathe size too small Increase swathe or travelling
speed
Cutting knives evade too early Check springs of knife protection
system, replace if necessary