Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual

Page: 232 / 327

Service and maintenance of machine
Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18 232
Every 250 service hours
•
Check compressed-air brake system for tightness:

The pressure in the compressed-air reservoir of the unhitched vehicle must not drop
more than 0.15 bar within 10 minutes.
•
Check:

all bearings,

the oil level of all gearboxes, top up if necessary,

all cables for visible defects, have them replaced if necessary.
•
Drawbar lug: Check for wear and screwed connection:

borehole diameter of drawbar lug 40: max. 41.5 mm,

admissible wear at the angular cross-section of the drawbar lug: max. 2.5 mm.
•
Have hydraulic oil filter replaced.
•
Check the oil level in the oil storage tanks at the dash pots, top up if necessary.
•
Grease the chains of the beaters (optional extra).
•
Check drawbar connection, retighten if necessary:

Tightening torque of crown nut: 800+50 Nm,
•
Lubricate the rollers of the knife protection system and check them for smooth running on both
sides.
Every six months
•
Check the following components at the electro-hydraulic forced steering axle system SES
(optional extra):

The angle sensor linkage for mechanical damage, corrosion, wear, contamination and
clearance. Have damaged parts immediately replaced by an authorised workshop.

The steering cylinders for oil leakage at the cylinder rod seal and scores in the cylinder
rods. Clean the cylinder rods from contamination.

The linkage of the steering cylinders for corrosion and firm seating. Have damaged parts
immediately replaced by an authorised workshop.

The hydraulic block for corrosion and oil leakage at the screwed connections. Have
corroded parts immediately replaced by an authorised workshop.