Strautmann Giga-Vitesse CFS 3602, Operating Instructions Manual, Page: 145 / 327

Operation
145 Giga-Vitesse CFS 3602 - 4402, Giga-Vitesse CFS 3602 DO - 4402 DO 03.18
6.1.3.11 Reverse transport floor
Risk due to failure of components caused by frequent or long
reverse of transport floor!
Observe the fact that the feed direction of the transport floor is only
allowed to be reversed for a short time (max. 3 seconds).
Check the transport floor chains for proper tension every day, in order
to prevent material damage.
Reverse:
•
only for a short time,
•
only in case of emergency,
•
if the slip clutch responds during discharge or
•
in order to reduce the pressing power which the loaded
material applies to the beaters.
1. Press the key to switch the
transport floor feed off.
2. Press the key.
The transport floor starts running and
conveys the loaded material away from
the beaters for a maximum time of 3
seconds. The "Reverse feed" symbol
appears.
The screen shows:
6.1.3.12 Crossover conveyor ccw rotation/cw rotation on
The preferred sense of rotation of the crossover conveyor is set in
the
SET menu.
1. Press the key once.
The crossover conveyor starts to run in the
most recently set direction.
2. Press the key again.
The sense of rotation of the crossover
conveyor alternates between cw and ccw.
The screen shows:
or