Siemens SINAMICS S120, Function Manual

Page: 757 / 1094

Communication
11.1 Communication according to PROFIdrive
Drive functions
Function Manual, 11/2017, 6SL3097-4AB00-0BP5
757
Error
value
Meaning Remark Additional
info
0x07 Description element cannot be
changed.
Modification access to a description element that cannot be
changed.
Subindex
0x09 No description data available. Access to a description that does not exist (the parameter
value exists).
–
0x10 Read job will not be executed. The read request is refused because know-how protection is
active.
0x0B No operating priority. Modification access with no operating priority. –
0x0F No text array exists. Access to a text array that does not exist (the parameter
value exists).
–
0x11 Request cannot be executed due to
operating status.
Access is temporarily not possible for unspecified reasons. –
0x14 Illegal value. Modification access with a value that is within the limits but
is illegal for other permanent reasons (parameter with de-
fined individual values).
Subindex
0x15 Response too long. The length of the present response exceeds the maximum
transfer length.
–
0x16 Illegal parameter address. Illegal or unsupported value for attribute, number of ele-
ments, parameter number, subindex or a combination of
these.
–
0x17 Illegal format. Write request: Illegal or unsupported parameter data format. –
0x18 Number of values inconsistent. Write request: A mismatch exists between the number of
values in the parameter data and the number of elements in
the parameter address.
–
0x19 Drive object does not exist. You have attempted to access a drive object that does not
exist.
–
0x20 Parameter text cannot be changed – –
0x21 Service not supported. Illegal or unknown request ID –
0x65 Parameter presently deactivated. You have tried to access a parameter that, although availa-
ble, does not currently perform a function (e.g. n control set
and access to a V/f control parameter).
–
0x6B Write access for the enabled control-
ler.
Write access is possible while the device is in the "Controller
enable" state.
Pay attention to the parameter attribute "changeable" in the
SINAMICS S120/S150 List Manual (C1, C2, U, T).
–
0x6C Parameter %s [%s]: Unknown unit. – –
0x6D Parameter %s [%s]: Write access
only in the commissioning state,
encoder (p0010 = 4).
– –
0x6E Parameter %s [%s]: Write access
only in the commissioning state,
motor (p0010 = 3).
– –
0x6F Parameter %s [%s]: Write access
only in the commissioning state,
power unit (p0010 = 2).
– –
0x70 Parameter %s [%s]: Write access
only in the quick commissioning
mode (p0010 = 1).
– –