System Input Transmission
84
Siemens Building Technologies
Fire Safety & Security Products
07.2009
16.1 Transmission CMS/ARC 1 & 2
Transmission with a protocol (Menu ARC parameter “protocol”)
No Transmission
The input won’t be transmitted.
When a transmission is chosen, define the following parameters.
Alarm Code
Alarm code depends on the chosen protocol.
Invert Beg/Rest
Invert the alarm and the restore event for the ARC.
Transm. to CMS/ARC
Transmission
Restore to CMS/ARC
Sending an event to the ARC, when the alarm is off again.
Transmission without a protocol, Vocal (Menu ARC parameter “protocol”)
No Transmission
The input won’t be transmitted.
When a transmission is chosen, define the following parameters.
Transm. to CMS/ARC
Transmission
Message
Alarm messages 1 to 6 can be chosen.
NOTE
The Alarm and the Help messages can be recorded accord-
ing to the Engineer menu “Recording of messages”
16.2 Service 1 & 2
Transmission to Sylcom or Pager
Service 1
and 2
This parameter defines whether or not the last 10 events of the engineer log is to be transmitted to service station 1 after
triggering of a transmission line. Two different options can be chosen for this transmission.
z
Immediate transmission after triggering of the transmission line.
z
Transmission only on unset.
"Service transmission" parameter in the "Other Telecom Options" (TM65)in the engineer menu. This parameter applies
to both stations.
Transmission
On full set:
All programmed transmission lines are transmitted.
NOTE
All transmissions related to partition 1 can also be set for each partition independently.
NOTE
Service 2 is used to send SMS to a mobile phone. For this, the according input lines must be en-
abled for transmission.
For this feature the SMN43 is required.
Summary of Contents for SI120
Page 99: ......