Siemens HydroRanger 200 HMI, Operating Instructions Manual

Page: 60 / 404

Commissioning
6.4 PROGRAM mode
HydroRanger 200 HMI
58
Operating Instructions, 06/2018, A5E36281317-AC
Changing a numeric value
1.
Navigate to the desired parameter.
2. When selected, the current value is displayed.
3. Press RIGHT arrow to open Edit mode. The cursor position is highlighted.
4. Use LEFT and RIGHT arrow to move cursor to digit position you wish to change.
5. As each digit is highlighted (selected), use the UP and DOWN arrow to increase
or decrease the digit respectively.
6. While decimal point is selected, use UP and DOWN arrow to shift decimal
position.
7. To escape without saving your changes, press LEFT arrow continually until ESC is
highlighted. Press LEFT arrow again to escape without saving changes. Otherwise,
when new parameter value is correct, press RIGHT arrow continually until OK is
highlighted.
8. Press RIGHT arrow to accept the new value. The LCD returns to parameter view and
displays the new selection. Review for accuracy.
①
Parameter name
②
Parameter number
③
Current value