Siemens HydroRanger 200 HMI, Operating Instructions Manual

Page: 198 / 404

Parameter reference
8.6 Setup (2.)
HydroRanger 200 HMI
196
Operating Instructions, 06/2018, A5E36281317-AC
Control Type Relay control
*OFF Relay set off, no action (preset).
Level Based on level setpoints ON and OFF.
Alarm Low Low Alarm
Low Alarm
High Alarm
High High Alarm
General In-bounds When level enters the range between ON and
OFF setpoints.
Out-of-bounds When level exits the range between ON and
OFF setpoints.
Rate of Change Based on rate setpoints ON and OFF.
Temperature Based on temperature setpoints ON and OFF.
LOE Loss of echo; when echo is lost.
Cable Fault When the circuit to a transducer is opened.
Flow Totalizer Every 10
y
units [Mantissa (2.10.2.2.)
(Page 213) - Relay Duration (2.10.2.4.)
(Page 215)]
Flow Sampler Every y x 10
2
units [Mantissa (2.10.2.2.)
(Page 213) - Relay Duration (2.10.2.4.)
(Page 215)] or time duration [Relay Interval
Setpoint (2.10.2.6.) (Page 215)]
Pump Fixed Duty Assist At fixed ON and OFF setpoints and allows
multiple pumps to run or for rake control.
Fixed Duty Backup At fixed ON and OFF setpoints and allows only
one pump to run.
Alternate Duty Assist At rotating ON and OFF setpoints and allows
multiple pumps to run.
Alternate Duty Backup At rotating ON and OFF setpoints and allows
only one pump to run.
Service Ratio Duty Assist On service ratio at ON and OFF setpoints and
allows multiple pumps to run.
Service Ratio Duty Backup On service ratio at ON and OFF setpoints and
allows only one pump to run.
First In First Out As Alternate Duty Assist, resets the relay from
staggered OFF setpoints.
Control Flush Valve Used to control a pump flushing device based
on Flush Systems [Flush pump (2.10.3.2.)
(Page 216) to Flush duration (2.10.3.5.)
(Page 217)].
Communication Based on input from external communications.
For more information, see Modbus register
map (Page 328).