SICK 1094474, Operating Instructions Manual, Page: 152 / 172

Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
4 CurrentMonitoringCaseNoTable1
5 Reserved DeviceError Applicatio‐
nError
1) Cut-off paths 5 to 8 are only available for the Pro performance package.
13.6.2 Alarms
Table 47: Available alarms (degree of difficulty: need for maintenance)
Number Severity Description Troubleshooting
64 Error Incorrect F destination address
(F_Dest_Add) set
b
Check the PROFIsafe parameters of the
module.
65 Error Invalid F destination address (F_Dest_Add)
set
b
Check the PROFIsafe parameters of the
module.
66 Error Invalid or incorrect F source address
(F_Source_Add) set
b
Check the PROFIsafe parameters of the
module.
67 Error The fail-safe monitoring time (F_WD_Time)
is set to an invalid value of 0 ms
b
Check the PROFIsafe parameters of the
module.
68 Error The set parameter F_SIL exceeds the
safety integrity level (SIL) of the device
b
Check the PROFIsafe parameters of the
module.
69 Error The set parameter F_CRC_Length does not
match the length of the received CRC val‐
ues
b
Check the PROFIsafe parameters of the
module.
70 Error F parameter version set incorrectly
b
Check the PROFIsafe parameters of the
module.
71 Error Inconsistent F parameter block received
(CRC1 error)
b
Rebuild and load the safety program.
72 Error Device-specific or unspecified diagnostic
message
75 Error iParameter inconsistent (F_iPar_CRC error)
b
Check the set F_iPar_CRC.
b
Process image without checking the
F_iPar_CRC.
76 Error F_Block_ID not supported
b
Check the PROFIsafe parameters of the
module.
77 Error PROFIsafe transmission error: data incon‐
sistent (CRC2 error)
b
Check wiring for damage and possible
electromagnetic interference (EMC).
78 Error PROFIsafe transmission error: Monitor‐
ing time (F_WD_Time or F_WD_Time_2
expired)
b
Increase, if necessary, the watchdog
time set in the PROFIsafe parameters.
256 Need for mainte‐
nance Error in application of the safety laser
scanner
b
Check the configuration, control and
process of the machine.
257 Need for mainte‐
nance Internal error in the safety laser scanner
b
Restart device.
b
Replacing the safety laser scanner.
258 Need for mainte‐
nance Contamination warning
b
Check the optics cover for damage.
b
Clean the optics cover.
259 Need for mainte‐
nance Contamination error All safety outputs in the OFF state.
b
Check the optics cover for damage.
b
Clean the optics cover.
260 Need for mainte‐
nance Tamper protection (reference contamina‐
tion field) The safety laser scanner does not detect
any contour within the configured toler‐
ance band of the reference contour field.
All safety outputs in the OFF state.
13
TECHNICAL DATA
152 O P E R A T I N G I N S T R U C T I O N S | outdoorScan3 – PROFINET 8027931/2022-10-24 | SICK
Subject to change without notice