Satelec Implant Center 2, User Manual

Page: 7 / 248

- a grounded power cord (Fig. 1-5),
- an LCD (Liquid Crystal Display) touch screen (Fig. 1-
6),
- a motor cord connector (Fig. 1-7),
- two peristaltic pump housings (Fig. 1-8),
- a cord connector for the two ultrasonic functions
(Fig. 1-9),
- a N
EWTRON
L
ED
scaler cord (Fig. 1-10),
- a N
EWTRON
L
ED
handpiece or a P
IEZOTOME
2 L
ED
handpiece with its cord (Fig. 1-11) (according to
option).
Located at the back of the unit are:
- 1 power cord socket with ground pin (Fig. 2-1),
- 1 footswitch connector (Fig. 2-2),
- 1 fan (Fig. 2-3),
- 2 bracket holders (Fig. 2-4),
- 1 power switch (Fig. 2-5).
- 1 potential equalization connector (Fig. 2-6)
3. 2 TECHNICAL DESCRIPTION
a) LCD touch screen
The LCD touch screen (Fig. 3) is used to define the
settings of your I
MPLANT
C
ENTER
2.
The I
MPLANT
C
ENTER
2 is adjusted by applying moderate
pressure to the screen keys.
Identification of key areas common to all modes (Fig.
3):
- 4: Reduce irrigation flow rate.
- 5: Increase irrigation flow rate.
- 6: Reduce value.
- 7: Increase value.
Identification of information display areas common to
all modes (Fig. 3)
- 2: Irrigation flow rate value.
- 9: Operating fault indicator.
Identification of key areas common to all modes that
also display information (Fig. 3)
- 1: Flush/prime.
- 3: Irrigation ON/OFF.
- 8: Save, store data.
- 10: Select footswitch mode.
- 11: ON/OFF of light function on handpiece
- 12: Select mode (according to connected handpiece
type).
Key areas and displays specific to the selected mode
P
IEZOTOME
mode :
Identification of information display areas (Fig. 4)
- 13: Selected program power level.
Identification of key areas that also display
information (Fig. 4)
- 14: Select program: D1, D2, D3, D4.
N
EWTRON
mode :
Identification of information display areas (Fig. 5)
- 15: Selected program power level.
Identification of key areas that also display
information (Fig. 5)
- 16: Select program: Soft, Medium, High, Boost.
I-S
URGE
mode :
Identification of information display areas (Fig. 6)
- 17: Contra-angle ratio.
- 18: Motor speed value.
- 19: Motor delivered torque value.
Identification of key areas (Fig. 6)
- 20: Adjust contra-angle ratio.
- 21: Adjust motor speed.
- 22: Adjust motor delivered torque.
Identification of key areas that also display
information (Fig. 6)
- 23: Select micro-motor rotation (clockwise or
counterclockwise).
- 24: Select program: P1, P2, P3, P4.
7