Satelec Implant Center 2, User Manual

Page: 13 / 248

The torque (Fig. 6-22) value is displayed (Fig. 6-
19).
c) Selecting a contra-angle
Selecting a pre-programmed contra-angle:
Press button (Fig. 6-20): the preprogrammed
contra-angle options are displayed (Fig. 8).
Select a multiplier contra-angle using the red buttons
(Fig. 8-35) or a direct contra-angle using the blue
button (Fig. 8-36) or a divider contra-angle using the
green buttons (Fig. 8-37).
The value of the selected contra-angle is displayed
(Fig.8-38).
The maximum permitted speed (Fig.8-39) and torque
(Fig.8-40) are displayed for each contra-angle.
Button (Fig. 8-32) is used to return to the main
screen without saving the changes.
Confirm the selected contra-angle by pressing button
(Fig. 8-34); the main screen is displayed.
Programming a user-defined contra-angle:
I
MPLANT
C
ENTER
2 enables specific contra-angles to be
used. A contra-angle value can be programmed.
On the main screen press button (Fig. 6-20); the
preprogrammed contra-angle options are displayed
(Fig. 8).
Press button (Fig. 8-33); the button is
highlighted.
Program the contra-angle using the numeric keypad
(Fig. 7-31).
The programmed contra-angle value is displayed (Fig.
7-25).
Press button (Fig. 7-29) to delete the last digit.
Press button (Fig. 7-28) to return to the main
screen without saving the changes.
Confirm your customization of the contra-angle by
pressing button (Fig. 7-30); the main screen is
displayed.
The maximum permitted speed (Fig. 6-18) and torque
(Fig. 6-19) are displayed for the programmed contra-
angle.
d) Speed adjustment
On the main screen, press button (Fig. 6-21); the
speed adjustment screen is displayed (Fig. 7).
Program the speed using the numeric keypad (Fig. 7-
31).
The programmed speed is displayed (Fig. 7-26).
Press button (Fig. 7-29) to delete the last digit.
Press button (Fig. 7-28) to return to the main
screen without saving the changes.
Confirm the speed adjustment by pressing button
(Fig.7-30); the main screen is displayed.
Note : The instrument speed can be adjusted directly
using buttons or (Fig. 3-6 and 3-7) for
programs , or even when the
multifunction footswitch is switched on.
To obtain a stable speed adjustment result, it is
recommended to press the footswitch fully (Fig. 11-
1).
Pressing buttons or (Fig. 3-6 and 3-7)
increases or reduces the speed value.
Pressing and holding buttons or (Fig. 3-6 and
3-7) for longer than 3 seconds causes faster increase
or reduction of the speed value.
If a torque or speed value outside the permitted
range is entered, !min! or !max! is displayed. The
maximum or minimum permitted value is then
displayed, depending on the case.
13