Satelec Implant Center 2, User Manual

Page: 15 / 248

15
and progressive .
Important:
In progressive mode, for programs D1 to D3, the
delivered power ranges between power level 1 of
program D3 and the configuration defined by the
user (program and power level).
In progressive mode, the power delivered by
program D4 ranges only between levels 1 and 5,
according to the value defined by the user.
If necessary, select handpiece light function ON/OFF
by pressing button (Fig. 3-11).
Confirm the new settings by pressing button
(Fig. 3-8).
The saving of the various settings is confirmed by an
audible signal and a visual signal (button flashing).
Repeat this sequence if necessary in order to adjust
all the programs.
Caution: The tips designed for P
IEZOTOME
2 and
I
MPLANT
C
ENTER
2 are not compatible with P
IEZOTOME
and I
MPLANT
C
ENTER
, and vice versa.
7. 7 NEWTRON FUNCTION
Important:
A scaler cord and its N
EWTRON
L
ED
handpiece must
be connected to the device in order to be able to
configure the various settings.
The N
EWTRON
L
ED
function settings can be
customized by the user.
Select the N
EWTRON
function by pressing button
(Fig. 3-12) or by pressing the footswitch
button (Fig. 11-5).
On the LCD screen, the N
EWTRON
tab must be
highlighted.
Select the program for which settings are to be
adjusted by pressing buttons , ,
or (Fig. 5-16) or by pressing the footswitch
button (Fig. 11-3).
Adjust the power level according to the TipBook
recommendations.
If necessary, modify the program power level (1 to
10) using buttons (Fig. 3-6) and (Fig. 3-7).
The power level of the program concerned is shown
as a number and a bar-graph (Fig. 5-15).
Modify the footswitch type if necessary by pressing
button (Fig. 3-10) to toggle between ON/OFF and
progressive.
If necessary, select handpiece light function ON/OFF
by pressing button (Fig. 3-11).
Confirm the new settings by pressing button (Fig.
3-8). The saving of the various settings is confirmed
by an audible signal and a visual signal (flashing
button).
Repeat this sequence if necessary in order to adjust
all the programs.
7. 8 TOOLBOX
Important:
I
MPLANT
C
ENTER
2 has a
T
OOLBOX
function used to
make various adjustments, including screen
brightness, handpieces light off time-out, audio
volume and factory configuration reset.
To access the T
OOLBOX
function, switch OFF the
device, wait four seconds, switch the device ON
again, then press button (Fig. 9-41) on the
welcome screen (Fig. 9).