Rohde & Schwarz Scope Rider RTH1002, User Manual

Page: 68 / 530

Waveform Setup
R&S
®
Scope Rider RTH
68 User Manual 1326.1578.02 ─ 12
Remote command:
TRIGger:LEVel<m>:SLEW:UPPer
on page 325
TRIGger:LEVel<m>:SLEW:LOWer
on page 325
Slope
Sets the edge direction for the trigger. You can trigger on:
●
rising edge, that is a positive voltage change
●
falling edge, that is a negative voltage change
●
rising and falling edge
Remote command:
TRIGger:SLEW:SLOPe
on page 325
Range
Defines the time limits of the slew rate. The comparisons are the same as for the width
trigger, see
"Range" on page 56.
Remote command:
TRIGger:SLEW:RANGe
on page 325
Time
Sets the slew rate for comparisons equal, unequal, shorter, and longer.
Remote command:
TRIGger:SLEW:RATE
on page 325
±Tolerance
Sets a tolerance range
Δ
t to the specified Time if the comparison range is equal or
unequal.
Remote command:
TRIGger:SLEW:DELTa
on page 326
Min Time / Max Time
Set the lower and upper time limits if "Inside" or "Outside" is set for comparison.
Remote command:
TRIGger:SLEW:MINWidth
on page 326
TRIGger:SLEW:MAXWidth
on page 326
3.6.11 Data2Clock Trigger (R&S RTH-K19)
With the Data2Clock trigger - also known as setup/hold trigger - you can analyze the
relative timing between two signals: a data signal and the synchronous clock signal.
Many systems require, that the data signal must be steady for some time before and
after the clock edge, for example, the data transmission on parallel interfaces.
The reference point for the time measurement is defined by clock level and clock edge.
► [SETUP] key > "Trigger Type" = "Data2Clk"
Trigger