Rohde & Schwarz Scope Rider RTH1002, User Manual

Page: 418 / 530

Remote Control Commands
R&S
®
Scope Rider RTH
418 User Manual 1326.1578.02 ─ 12
Setting parameters:
<Deviation> Absolute difference between mean value and upper/lower scal-
ing value
Example:
LOGGer:MEASurement1:VERTical:MEAN 10, 1
Sets the mean value to 10, and the deviation to 1. Thus, the
upper range is
10 + 1 = 11 , and the lower range is 10 - 1 = 9 .
Firmware/Software: FW 1.60 and higher
15.10.3 Cursor in Logger Mode
15.10.3.1 Cursor Settings
LOGGer:CURSor[:STATe]
............................................................................................... 418
LOGGer:CURSor:TYPE
..................................................................................................418
LOGGer:CURSor:SCPLing
............................................................................................. 418
LOGGer:CURSor:COUPling
............................................................................................419
LOGGer:CURSor:SCReen
..............................................................................................419
LOGGer:CURSor[:STATe] <Enabled>
Enables or disables the logger cursor measurement.
Parameters:
<Enabled> ON | OFF
*RST:
OFF
LOGGer:CURSor:TYPE <Value>
If data logging is running for more than 2 days and 7 hours, the logger compresses 4
logging values into a minimum, average and maximum value. The command defines
which of these values are measured at the cursor position.
For logging periods shorter than 2 days and 7 hours, the command is not relevant.
Parameters:
<Value> MINimum | AVERage | MAXimum
*RST:
AVERage
LOGGer:CURSor:SCPLing <TrackScaling>
If ON, the position of the cursor lines is adjusted when the horizontal scale is changed.
If OFF, the cursor lines remain on their position on the display when the scaling is
changed.
Data Logging