Rohde & Schwarz Scope Rider RTH1002, User Manual

Page: 235 / 530

Protocol Analysis
R&S
®
Scope Rider RTH
235 User Manual 1326.1578.02 ─ 12
"Slow Identifier and Data"
Sets the trigger to a combination of identifier and data condition from
the slow channel. The instrument triggers at the end of the last trans-
mission sequence which includes the last serial bits of the slow chan-
nel.
"Error condition"
Identifies various errors in the frame. You can select one or more
error types as the trigger condition.
Remote command:
TRIGger:SENT:TYPE
on page 478
Status Pattern
Specifies the status pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 3.6.12.1, "Pattern Definition" , on page 70.
Remote command:
TRIGger:SENT:STATus
on page 479
Status Relation
Defines how the specified status pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Remote command:
TRIGger:SENT:SCONdition
on page 479
Data Pattern
Specifies the data pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 3.6.12.1, "Pattern Definition" , on page 70.
Remote command:
TRIGger:SENT:DATA
on page 478
Data Relation
Defines how the specified data pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Remote command:
TRIGger:SENT:DCONdition
on page 478
Identifier Pattern
Specifies the identifier pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 3.6.12.1, "Pattern Definition" , on page 70.
Remote command:
TRIGger:SENT:IDENtifier
on page 479
SENT (Option R&S RTH-K10)